Cleaning Packages
|
|
|
Package #1 - Interior Clean
|
Package #2 - Exterior Clean |
Package #3 - Interior/Exterior Clean
|
Our professional team will;
Throughly vacuum, clean all
interior upholstery and apply
UV protectant, clean all interior
fiberglass, wipe dash and
gauges, shine all glass
surfaces on interior and exterior |
Get that shine back from the dull!
Our team will wash, apply a coat
of premium top quality hull wax
on all exterior glass surfaces including
top surface to below gunnels and
buff to bring back that "New" appearance.
Some finishes may require a finishing
compound to enhance the finish. |
Really show off your prize!
The pros will perform all of
the items in package #'s 1 and 2.
Start your boating season with that
"New Boat feeling".
You know it always works
better when it's clean!
|
Up to 17' $129.95
18' to 22' $139.95
24" & Up Call for quote |
Up to 17' $360.00
18' to 22' $390.00
24" & Up Call for quote |
Up to 17' $465.00
18' to 22' $505.00
24" & Up Call for quote |
| |
|
|
Package #4 - Bottom Protection
|
|
|
Keep the slime in the lake!
There is a revolutionary new
bottom coat now available that will
be hand applied to the "Wet"
surface (Bottom) of the boat
that will resist all that slime from
building up on the bottom. This is
not a traditional "Anti foal" paint,
but a wax type compound that is
hand rubbed onto the bottom.
Good for the season! |
|
|
Bottom protection package
$15.00 per ft. |
|
|
| |
|
|
Service Packages
|
|
|
Package #5 - Impeller Change
|
Package #6 - 21-Point Inspection |
Package #7 - Trailer Service |
Keep the Pressure!
The impeller is the heart of your
engine running cool and shutting you
down from overheating and doing major
internal damage to your engine. It is the
"Pump" that draws cooling water from the
lake to circulate and keep the engine
running at the proper operating
temperature. Our technichians will
remove the lower unit, replace the
impeller and reinstall the lower unit.
They will also ensure the thermostat is
operating properly to maintain the proper operating temperature of the engine
|
Preventative Visual key point inspection of major components
- Prop shaft inspection and grease
- Pressure test gear case
- Inspection of lower unit drain filler washer and replace if necessary
-
Bellows inspection
- Anode inspection
- Outdrive to engine alignment
-
Gimbal bearing inspection and grease
-
Battery condition inspection
-
Spark plug inspection
-
Compression test, ignition test
-
Distributor and rotor inspection
-
Carburetor inspection and set up
-
Shift linkage inspection
- Inspection of all hoses
-
Check belts for cracks and wear
-
Fuel line inspection
-
Fuel tank inspection
-
Cooling system test
-
Key switch inspection
-
Gauge inspection
|
Ensure you get to where
you are going!
Our technicians will pull the
wheels off the axle, inspect the
wheel bearings for grease
starvation, damaged bearing
carriers and seals (Keeps the water out!).
Inspect general structural integrity of
the trailer frame, bolts for damage,
the coupler (tongue) will secure
to the vehicle tow ball,
lights and wiring for damage,
broken lenses or blown bulbs,
support rollers or bunks,
suspension springs for damaged,
broken or missing springs, and
finally inspect the tires
|
|
Recommended Annually
Mercruiser Bravo III/I $225.95
Mercruiser Alpha I/Gen II $155.95
OMC Cobra $129.95
Outboard 20HP & lower $69.95
Outboard 20HP & higher $155.95 |
Inspection of key points
on your boat
$99.99 |
Complete Safety Inspection $49.95 |
| |
|
|
| Package #8 - Tune Up I/O |
Package #9 - Tune Up OB |
Package #10 - 20/100 Hour |
Make sure it start when
the suns out!
A properly "Tuned" engine will
start easier, run smooth, accelerate
quickly and save you $$ in fuel.
We will replace the spark plugs,
wire set, ignition cap , rotor
condensor (If so equipped),
fuel filter and reset components
to manufacturers specifications. |
Make sure it start when
the suns out!
A properly "Tuned" engine will
start easier, run smooth, accelerate
quickly and save you $$ in fuel.
We will replace the spark plugs,
wire set, ignition cap , rotor
condensor (If so equipped),
fuel filter and reset components
to manufacturers specifications. |
This inspection is the manufacturers
recommendation to maintain the
performance and the "New" in your
boat and to ensure your warranty
is adheired to
1. Replace Engine Oil And Filter
2. Remove Lower Unit And
Check Alignment
3. Check Carb/EFI Settings
And Operation
4. Change Lower Drive Unit Oil
5. Inspect Grease Drive Splines
And U-Joints If Req'd
6. Check all belts and hoses
As per manufacture specs
******PART COSTS ARE EXTRA*******
|
Recommended every 2 years
4 Cylinder $139
6 Cylinder $169
8 Cylinder $189 |
Recommended every 2 years
2 Stroke $69.99
4 Stroke $89.99 |
Recommended by
engine manufacturer
4 Cylinder I/O $214.95
6-8 Cylinder I/O $214.95
2 Stroke OB $159.95
4 Stroke OB $179.95 |
| |
|
|
Package #11 - Transom Seal Kit
|
|
|
Leave the water in the lake...
not in your boat!
A leaking transom seal can spoil
your hard earned weekend fun
with friends and family.
We will inspect the seal of the
outdrive to the transom of the boat
for any cracks or damage that may
allow water to enter into the bilge
of your boat. We will also inspect
the driveshaft and exhaust
"Bellows" for secure and damage |
|
|
Recommended by engine manufacturer
From $269 based on engine
|
|
*All pricing is labour only. Parts extra* |